Did You Know when exporting a mesh for Fluent, the user is asked if he/she would like to re-use an existing setup *.cas file, see below.

This is very helpful when morphing a Fluent mesh in HM. You can load the Fluent *.cas file into HM, morph the model, export the morphed mesh and reuse the existing setup from the initial *.cas file. No additional setup in Fluent is required then. Using this approach you can perform a manual DOE. Using the result data from the initial run (*.dat file), you can perform a restart, which cuts down the run time for the morphed design (September 17, 2012)

Click Here for Software,Training and Support for your Team!
Click Here for Software,Training and Support for your Team!

Have a question or comment?

Post your comment/question on our user forum.